eiginh;43691 said:
Left C, If I purchase the kit from oregon aqua design will I need other fittings?
Hi eiginh
To my knowledge, you will not need any extra fittings with Jeremy's Fabco valve, Clippard solenoid, JBJ BC, etc kit unless you assemble it differently or there is a mistake.
Be sure that you order the optional Fabco valve. The stock Clippard needle valve is really bad.
Jeremy has a note on his site that says that the JBJ bubble counter is not available at this time. You can click on "no bubble counter" in the ordering section. This way you will get an inline BC, but not the JBJ BC and save $10. I like inline BC's better than JBJ or Milwaukee BC's which are designed to be mounted on the regulator after the solenoid.
Jeremy could even have the JBJ BC's now. Should you want to get a JBJ BC, Fabco needle valve, Clippard solenoid and the kit, let Jeremy know and you should be fine.
You could also purchase Jeremy's kit for use with the Fabco valve if you ordered your BC elsewhere.
You can order the JBJ BC from AquaticMagic.com.
http://shop.ebay.com/?_from=R40&_tr...=jbj+bubble+counter&_sacat=See-All-Categories
Getting Jeremy's kit with the Fabco valve and JBJ BC should only be a minor problem. You will have to contact Jeremy concerning parts availability.
If it was my regulator, I would use a Clippard or Burkert (maybe a Parker that is on ebay.) solenoid, an Ideal, Swagelok, Nupro or Whitey needle/metering valve and any of the three solenoids mentioned with a BC mounted inline and not on the needle/metering valve.
I wish you good luck with your regulator and kit. SuMo has a better kit than OAD's which includes the JBJ BC, Clippard solenoid, Ideal metering valve, CO2 tubing, Clippard brass check valve and pipe dope. It is $80 to $100 more, though.
Left C