Hi everyone,
Trying to get my own trace element mix due to looking at the one I had available at the shops being to high in a certain element which would cause harm to fish.
I have all the ingredients but not sure about what quantity to mix. The following ingredients I have on hand due to being told that this is
what I required:
-EDTA Iron 13%
-EDTA Manganese 13%
-EDTA Zinc 15%
-EDTA Copper 15%
-Borax 10.5%
May be missing some ingredients. But any help for recipes of what quantity will be greatly appreciated.
Or how do reduce the percentage of each item. For example
Iron 13% to 7.15%. Would be 55g to 100ml distilled water
How would I dilute the strength without using water? Is there some other chemical?
Thanks for any help greatly appreciated
Trying to get my own trace element mix due to looking at the one I had available at the shops being to high in a certain element which would cause harm to fish.
I have all the ingredients but not sure about what quantity to mix. The following ingredients I have on hand due to being told that this is
what I required:
-EDTA Iron 13%
-EDTA Manganese 13%
-EDTA Zinc 15%
-EDTA Copper 15%
-Borax 10.5%
May be missing some ingredients. But any help for recipes of what quantity will be greatly appreciated.
Or how do reduce the percentage of each item. For example
Iron 13% to 7.15%. Would be 55g to 100ml distilled water
How would I dilute the strength without using water? Is there some other chemical?
Thanks for any help greatly appreciated
Last edited by a moderator: