Red Temple problem

Grafalski

Prolific Poster
Feb 24, 2006
52
0
6
I need your help guys. I`m still having problem with red temple. Older leaves are getting cracks and holes.

Dosing 2 x /week :
1/4 Tsp of Potassium Nitrate
1/16 Tsp of Mono Potassium Phosphate (KH2PO4)
1/8 Tsp of Potassium Sulfate

1/4 tspn of magnesium sulfate once a week by water change ,
6ml TMG 3 x /week
29 galoon, 65 W for 12 hours/day+another 65W kicking in for 3 hours in the evening, CO2 mist method.
Flourite
PH 6.6, KH 5, GH 7
Water change 50% once a week (3/4 RO)

I`ll try to upload picture so you can take a look at this.
 

VaughnH

Lifetime Charter Member
Lifetime Member
Jan 24, 2005
3,011
97
48
88
Sacramento, CA
Re: Red Temple problem

You have the same size tank and lights that I have. I dose 1/4 tsp KNO3 and almost 1/8 tsp of KH2PO4 every other day, and 1/16 tsp CSM+B+iron on the alternate days. My "red temple" plant still grows pretty slowly, but I don't remember seeing any pinholes in the leaves. I also use CO2 with a CO2 mist system, at about 3-4 bubbles per second.
 

Grafalski

Prolific Poster
Feb 24, 2006
52
0
6
Re: Red Temple problem

I know that dosing looks OK but actually what leaves get it`s not a hole. It`s a crack (check the picture). I was thinking that maybe it`s a substrate problem. I have fluorite. What substrate do you have and what is your water PH, KH, GH?
I also read online that it`s good to add clay to regular substrate, mix it up and after that plant red temple itself.
 

VaughnH

Lifetime Charter Member
Lifetime Member
Jan 24, 2005
3,011
97
48
88
Sacramento, CA
Re: Red Temple problem

My substrate is Soilmaster Pro Select Charcoal, with a dusting of ground peat at the bottom. My water is a bit soft, low KH, but I haven't checked it for several months, so I don't know the numbers. Nor do I know the pH, since I quit checking that a few months ago too. It isn't real low, as I recall, so it must be around 6.4 or so. I don't see the benefit of adding clay to the substrate - I think both of our substrates are just fracted clay, so they provide the benefits of clay, as far as binding cations (?) goes. My red temple (Alternathera Reinickii v. Roseafolia) reacted very positively to the light increase when I went to 110 watts and began to grow redder and faster. My leaves may have some of that cracking on them too, but I'm not sure - not on the newer leaves for sure.
 

Tom Barr

Founder
Staff member
Administrator
Jan 23, 2005
18,699
786
113
Re: Red Temple problem

If you have decent Mg and are doing the rest, then that's CO2, CO2 and CO2.

Seen that a lot, looks just like the effect from low CO2.

Regards,
Tom Barr
 

VaughnH

Lifetime Charter Member
Lifetime Member
Jan 24, 2005
3,011
97
48
88
Sacramento, CA
Re: Red Temple problem

Tom Barr said:
If you have decent Mg and are doing the rest, then that's CO2, CO2 and CO2.

Seen that a lot, looks just like the effect from low CO2.

Regards,
Tom Barr
This just supports my thought that CO2 mist may not raise the overall level of dissolved CO2 in the water enough to avoid problems like BBA. Unless the mist is really, really fine, and the water current is all inclusive in the tank, you might see signs of a shortage of CO2, in spite of the massive dose of mist. I still get some BBA starting, and that with about 4X the bubble rate that I ran before I had the mist system and few BBA problems. That has persuaded me that I want a reactor either instead of or in addition to CO2 mist.
 

Grafalski

Prolific Poster
Feb 24, 2006
52
0
6
Re: Red Temple problem

Red temple is the only plant in my tank that shows cracks on old leaves.
My Co2 is pretty high - I add 3 bubbles/sec and when I try to add some more my fish start showing stress symptoms.
But I wonder if my Mg level is OK. Some young leaves are twisted and small (not growing). I`ll try to add some more and we`ll see what happens.

What do you suggest VaughnH? Co2 mist itself is not good enough?
 

VaughnH

Lifetime Charter Member
Lifetime Member
Jan 24, 2005
3,011
97
48
88
Sacramento, CA
Re: Red Temple problem

No, I'm not nearly ready to say that CO2 mist alone isn't good enough. I want to experiment with my newly made Barr internal venturi reactor for a few months first. If we just had a simple little gage that accurately told us how much CO2 was in the water it would be much simpler. But, I don't.

I rarely dose any magnesium, once I read my water company report, but, again I want to take the time to experiment with it before I decide if I need it. I also don't dose potassium except with KNO3, one more thing I may want to play around with later. So, I don't have any more ideas for you to try right now.
 

Tom Barr

Founder
Staff member
Administrator
Jan 23, 2005
18,699
786
113
Re: Red Temple problem

Amano seesm to do fine with mist only.

Regards,
Tom Barr